Let's use Crystal Serum Light of GTECHNIQ
Application:
- To apply Crystal Serum Light (CSL) make sure your vehicle is indoors and can stay indoors for 12 hours after application, do not apply in direct sunlight
- Applied at a temperature between 5°c and 25°c
- Wash and decontaminate W6 your paintwork thoroughly prior to application. If required, polish your paintwork, either by machine or hand, to remove any imperfections
- Spray Panel Wipe into a GTECHNIQ MF1 Microfibre Cloth and wipe down each panel in small sections
- Soak the application pad with 3 full measures of CSL from the pipette and work the liquid into the pad to get an even saturation
- Replace the lid on the bottle and set aside - do not keep the bottle in your hand as this promotes premature curing
- Apply in overlapping strokes to an area roughly 2ft by 2ft, or work to the bodylines of the vehicle
- Immediately 10 to 15 seconds remove residue with an MF1 cloth - you may need to buff the same area several times, but avoid doing it with too much force. We recommend the use of 2 cloths at any one time. Make sure the cloths are rotated during residue removal to prevent CSL curing in the cloth- this can make buffing residue difficult
- Inspect the surface for residue with a bright, diffused light source
- If you remove residue and it cured fully you should polish the area and reapply CSL
- As soon as you finish, put you MF1 cloths in water, wash and dry them as soon as possible
- Wait approximately 2 hours after applying CSL to apply EXO Ultra Durable Hydrophobic Coating, or C2 Liquid Crystal
- Store in a cool, dry place
- Use within 3 months of opening
